Tow Mate Wheel Watch - Installation

Wheel Watch

1. Connect 2 wires into power and earth terminals of the existing trailer 7 pin plug.
2. Clamp the Height sensors onto the axle
3. Connect the signal circuit to the sensors
   

Heat Sensor Attachment

1. Secure heat sensors on axle near each bearing.
2. Cover with suitable silicone sealer to protect from stone damage, waterproof and lock in position.

Brake Circuit Module

1. Mount the Monitor at the front of the caravan or trailer and run the wires down through the J-mould so they are not visible.
2. Connect the wires from the monitor to the wires from each brake drum with the splicers supplied.
3. Cable ties are supplied to make the cables secure.

Fits Most Suspensions

Click on your type listed below to view where to mount the height sensors.

Complete Installation and Operating Instructions

Click the manual below to view and download. (NB: requires Adobe Reader)

• Owners Manual
• Brake Circuit Sensor Manual